Computer-Assisted Audit Techniques (CAATs)

After reading this article you will learn about Computer-Assisted Audit Techniques (CAATs).

Introduction to Computer-Assisted Audit Techniques (CAATs):

ADVERTISEMENTS:

When planning the cost audit, the cost auditor should consider an appropriate combi­nation of manual and computer-assisted audit techniques (CAATs).

In determining whether to use CAATs, he should take into account:

(i) His computer knowledge, expertise and experience.

(ii) Availability of CAATs and suitable computer facilities.

(iii) Impracticability of manual tests.

(iv) Effectiveness and efficiency.

ADVERTISEMENTS:

(v) Timing.

In an EDP environment, the control procedures take basically two stages:

1. Manual Procedure—i.e. the clerical work done up to the translation of data into machine-sensible form. This stage, being manual, is subjected to usual internal control conditions and the Cost Auditor will have little difficulty in appraising them by means of ‘compliance test’ and ‘substantive’ test’.

2. Computer Procedures—i.e. the computer processing work. Auditing in this area is actually a complex activity, for which the Cost Auditor as a prudent person should develop himself for adequate EDP knowledge. Before he actually starts to conduct his audit in EDP environment, he should envisage to maintain an ‘Audit Control File’, as his valuable kit.

ADVERTISEMENTS:

The Computer Audit Control File may be built up containing full details of the system including:

(i) Copies of all source documents and the details of the checks that have been done to ensure their accuracy.

(ii) Details of physical control over source documents and any control totals on numbers, quantities, values, including the names of the personnel keeping these controls.

(iii) Full description of how the source documents are to be converted into input media, and the check-cum-control device.

ADVERTISEMENTS:

(iv) A detailed account of the manual internal controls contained in the system, e.g. separation of programmers from operators, control of assets from record keeping, etc.

(v) The arrangements for retaining source documents and input media for the required periods necessitating reconstruction of stored files in the event of error, mishap, loss, etc.

(vi) A detailed Flow Diagram of what takes place during the process run.

(vii) Details of all tapes or discs produced, including their layout, labelling, storage and retention, and

(viii) Copies of all documents of output and details of subsequent sorting and checking.

Steps for CAAT Applications:

The major steps to be undertaken by the cost auditor in the application of a CAAT in performing cost audit under EDP environment are as follows:

(a) Setting the objective of the CAAT application.

(b) Determining the content and accessibility of the entity’s files.

(c) Defining the transaction types to be tested.

(d) Defining the procedures to be performed on the data.

(e) Defining the output requirements.

(f) Identifying the audit and computer personnel who may participate in the design and application of the CAAT.

(g) Refining the estimates of costs and benefits.

(h) Ensuring that the use of the CAAT is properly controlled and documented.

(i) Arranging the administrative activities, including the necessary skills and computer facilities.

(j) Executing the CAAT application.

(k) Evaluating the results.

CAAT Audit Working Papers:

The standard of working papers and retention procedures for a CAAT should be consistent with that on the audit as a whole. It is advisable that the cost auditor should keep the technical papers relating to the use of the CAAT separate from the other cost audit working papers.

The cost auditor is expected to keep the following documents relating to the stages enumerated below, and his audit working papers should contain sufficient documentation to describe the CAAT application, such as:

(a) Planning:

i. CAAT objectives, duly defined in clear terms.

ii. Specific CAAT to be used considering the audit area and its nature and volume.

iii. Controls to be exercised in test runs and final runs with reference to data files, etc.

iv. Staffing, timing and cost.

(b) Execution:

(i) CAAT preparation and testing procedures and controls. .

(ii) Details of the tests performed by the CAAT.

(iii) Details of input, processing and output.

(iv) Relevant technical information about the computerised accounting system, such as computer files layouts.

(c) Cost Audit Evidence:

(i) Output provided.

(ii) Description of the audit work performed on the output.

(iii) Audit conclusions.

(d) Others:

Recommendations to the management. In addition, it may be useful for the cost auditor to document suggestions for using the CAAT in future years.

, , ,


Related pages


degree of combined leverage formulacapital budgeting decisions usually involve analysis ofproforma of bank reconciliation statementhca meaningfasb conceptual framework qualitative characteristicsdirect costing and absorption costingdifference between shares and debentures and bondsdupont chart analysisdebtors collection period ratioaccounting goodwill definitionwhy closing stock is not shown in trial balancehow to calculate ebitdouble column cash book formatdifference between monetary and nonmonetary assetscomprehensive income vs net incomecash flow and fund flowwhat does high employee turnover meanposting to ledger accountsoverhead absorption rate formulaprocedure of process costingtypes of indirect expensessib accountinghow to calculate directors remunerationrealisation in accountingproduction overhead formulaebit break evenbooks for accountsmethods of inventory valuationmrtp act 1969 notesorder of permanenceabsorption accounting definitionmm approach of dividend policycash flow fund flowstatement of comprehensive income formatobjectives of wealth maximizationimprest account formatmodigliani and miller theory on dividend policybank reconciliation example problemsreserve accounting entrieswhat is the difference between implicit and explicit costbrs statementdefinition of disequilibriumfinancial statements for a sole proprietorshipidle time variance formulamateriality principle accounting definitiondifference between static and flexible budgetinter firm meaningmeaning of rationingindirect tax notes in hindidefinition of overhead costcertainty equivalent coefficientprocess costing problems and solutionsphysiocrats theoryforex treasury managementvariable costing absorption costingwhat is trial balance why is it prepareddefine cost volume profit analysisdiminishing depreciation methodbearer debentures definitionordinary shares advantages and disadvantageswhat is relevant cost in accountingmeaning of petty in hindithe meaning of debentureinflationary financingfiscal federalism meaningbills of exchange discountingmonetary assets and liabilities exampleslimitation of accounting rate of returnclassifications of taxationexport factoring definitionexpense recognition principle accounting definitionsuspenses accountpromissory note in hindi